I followed the tutorial video exaclty as it was shown. I pasted the primary qr code first at the point then scanned it, after that i placed 6 pegs in a 10 meter range. At the moment it is showing the pegs placed correctly. But when when i save it the pegs are placed at some other point.
I have tried editing the pegs on same map and also creating a new map from scratch.
Picture for reference. You can see the pegs and access point code in 2 circles. The desired pin for these pegs are at the left. You can see a blue + (access point) and blue - (pegs).
Hi Bilal,
One of the main reasons for the 6 pegs not matching the placement in AR would be that the floor plan does not meet our recommendations for the pixel-per-meter / pixel-per-foot ratio. You can find more infomration about what our recommendations are here: https://www.arway.ai/faq?questionId=0b25ceef-2618-4ca1-9a11-ccf266d701b0&appDefId=14c92d28-031e-7910-c9a8-a670011e062d
You can also manually align the floor plan by following these instructions: https://www.arway.ai/faq?questionId=d4914633-b9f8-4f47-9a41-b932d6135914&appDefId=14c92d28-031e-7910-c9a8-a670011e062d
I hope this helps!